INSTRUCTIONS Merch Studio
>
INSTRUCTIONS

THANK YOU FOR PURCHASING MERCH STUDIO DTF TRANSFERS

Here are your pressing and care instructions:

pressing instructions


1. Use a lint roller to remove any lint on the t-shirt’s press area.

2. Pre-press the garment for 5-7 seconds to remove moisture.

3. Place the design on the garment and press according to “Press Settings” below. You may need to do a few test prints to find the optimal press settings for your specific equipment and environment.

4. THIS IS HOT PEEL FILM. DO NOT ALLOW TO GET COLD. After pressing, wait 5-10 seconds, then peel the film from one corner in one consistent motion.

5. Post-press the garment for 5 seconds.

*NOTE: When pressing, using a teflon sheet between the press and the design produces the best results

Press Settings


1. Actual press settings may differ due to equipment used and environmental conditions such as room temperature and humidity. 

2. Press at medium to high pressure.

3. 100% Cotton:  start at 230-260F for 15 seconds and adjust as necessary

4. Polyester Blend:  230-260F for 15 seconds and adjust as necessary 

5. Peel 5-10 seconds after pressing.

Care Instructions


Storage:

Transfers should be stored in a dry place, ideally in a Ziploc bag

Garment Care:

Wash garment with warm water. 

Tumble dry at “delicate” setting.

Do not iron design directly. If necessary, iron at low setting on the inner side of the garment 

Contact us if you have any questions and inquiries: 

 

QUOTES: quotes@merchstudio.co

CUSTOMER SERVICE: cs@merchstudio.co

Get PDF File
Your cart is empty
Search

Select Currency

{CC} - {CN}